Mazda MX-5 Fixings Trim Clips and Fasteners -ND (2015-)

This is probably the most common Mazda clip we sell. These are fitted to almost all modern Mazda cars produced since 2010. The clips fit into an 8m...

These small, black 6mm clips have a wide collar and are common on interior trims and panels. They are often used on boot linings, upholstery, roof ...

These chunky and strong clips and used on the sills of several different Mazda models. The clips are used to fasten the side skirts or plastic sill...

These interior door card clips are used on a wide range of Mazda cars to hold the interior door cards in place. Our clips include the foam sealing ...

Common on several Mazda models, these clips are normally used on bumpers undertrays, sill mouldings or other large panels and shields.

These green plastic moulding clips come with foam sealing washers. They are an identical and high quality alternative to the genuine Mazda part num...

Normally found on Mazda front or rear bumpers, these plastic fasteners expand when the centre pin is pushed in. They fit into a 5mm hole. The clips...

These yellow weatherstrip clips are fitted to most Mazda cars since 2000. The small clips fit inside the rubber seals that run around the doors, bo...

These fir tree clips are used to secure the under bonnet sound proofing insulation on most Mazda cars since around 2003. The clips fit in a 5.5mm h...

Very common across the Mazda range, this clip is used to fasten and secure a wide variety of parts. Uses include Mazda MX-5 sideskirt clips, CX-3 b...

This part is normally used on interior panels that sit flush against the dashboard or centre console. These trims are sometimes decorative or are u...

This clip is used by Mazda to secure the rubber seal that runs along the front or rear side of the bonnet. It's used on most modern Mazda cars incl...

These grey screw edge grommets or spire clips are used to join parts without necessitating damage to the metal bodywork. This part slides over the ...

These expanding rivets are normally used to attach loose fitting panels such as wheel arch linings or splash guards. They fit into an 8mm hole and ...

These long grey expanding push fit clips are unusual in that they only expand at the very tip. They are used by Mazda on front bumpers and some doo...

These plastic trim clips are used by Mazda, normally on exterior parts such as bumpers, grilles or radiator shields and guide.

This kit contains all the fasteners needed to attach the engine undertray panel on the vehicles listed below. We have researched and created these ...