Audi A3 Fixings Trim Clips and Fasteners -Mk3 8V (2012-)

Audi use this clip to attach a range of different parts on several of their models. The clip can be found on exterior trims such as wheel arch lini...

These are very common on modern Audi cars for underbody shields, covers and splashguards. The nuts are threaded and fit onto studs already attached...

There are two very similar clips used by Audi, Seat, Skoda and VW on most of their models. This version is 16mm long and there is also a 22mm versi...

A common screw grommet fitted to many Audi vehicles. The clip is used throughout and example uses are wheel arch linings, pillar trims, door cards,...

These locking star washers are suitable for attaching underbody noise and heat insulation. The corrosion resistant parts are used throughout the Au...

These are common on vehicles produced by Audi. The clip is normally used to hold plastic trims in position in locations such as dashboards, door ca...

These plastic pins are used to attach the rear tow eye covers on a number of Audi and Volkswagen models. The clip twists in to lock or unlock the a...

This is one of the most common sizes of screw used by Audi for the wheel arch linings on their vehicles.

This plastic fastener fits into an 8mm diameter hole and expands to securely lock in place when the centre pin is inserted. They are used by Audi o...

These are very widely used across the VAG group. The grommet is used on a large number of parts including around bumpers, sills, side skirts, wheel...

These metal spring fasteners are used to attach fascias and trim panels to items such as door cards, dashboards and seat backs. These parts are hig...

A simple push fit expanding plastic fastener which is only unusual due to the large head on the push pin. These types of clip are normally used on ...

These clips mount onto the bodywork or trim and allow a twist lock bolt to be secured. These are often used on removable access panels such as unde...

These black plastic clips fit into the doors or pillar around the B-pillar of the car. This is the pillar between the driver and passenger door. Th...

These single use 7mm black fir tree clips are used by Audi on several different models. The clips are black with a 20mm diameter head. They are use...

A simple plastic trim clip that expands when the centre pin is inserted. This type of clip is used on many vehicle and has lots of different uses. ...

This is a very common and very widely used clip. It's normally used on interior trims but can be for a very wide range of purposes. Door cards, pil...

This sprung clip is very simple. The clip squeezes together to be fitted and expands once it is in place. Most Audi vehicles use these to fasten bo...

This plastic washer is used with twist lock bolts and act to hold the removable covers in place onto rear bumpers of several Audi cars. The covers ...

A very common 16mm long black metal spring clip used for attaching fascias, pillar covers and interior trims. The fastener is common on a wide rang...

These metal springs are used to attach interior parts such as the interior pillar covers and door entrance sill trims.

These are a new style clip fitted to most Audi models after 2015. Earlier models of the Audi A3 also use this part. The clip attaches to a metal st...

This small set of fixings is used on some Audi vehicle to attach the rear tow eye or tow hitch cover panel. The set includes two twist lock plastic...

Restagraf are a Tier 1 fasteners supplier and they have created this kit of OE parts to fully refit the engine undertray. The kit contains every bo...