Mitsubishi Lancer Evo X Fixings Trim Clips and Fasteners -(2007-2016)

These 9mm push fit rivets are used on several Mitsubishi models including the Mitsubishi Lancer Evolution models 8, 9 and 10. They are used for att...

Small 6mm push fit clips used by Mitsubishi on a wide range of models. These are one of the most common Mitsubishi clips we stock and have been fit...

These 8mm plastic rivets are used on several modern Mitsubishi vehicles. The clips are a simple expanding push fit clip. The clip goes into an 8mm ...

Fitted to several Mitsubishi models, these clips are used for multiple purposes. They are found on wheel arch linings, bumpers, splashguards and in...

These are a very common clip used by a lot of different Japanese and European manufacturers. They fit into an 8mm hole and are used by Mitsubishi f...

These 8mm clips are common as wheel arch lining, engine bay and bumper clips. Our parts are all produced to the exact same specifications as the or...

This interior trim panel clip is widely used by Japanese manufacturers including Mitsubishi. The clips are normally used on door cards but will als...

These are side skirt and body moulding clips fitted to a number of Mitsubishi cars. We always supply this clip with the foam sealing washer which i...

These small white clips are widely used on Mitsubishi vehicles. They are used to attach trim panels or moulding strips. Example uses include L200 d...

Very widely used screw grommet that fits into a square hole measuring 8.5mm by 8.5mm. The clip is used by Mitsubishi to secure trim or parts to bod...

Mitsubishi bonnet insulation clips used to hold the fabric sound proofing panels in position on the underside of the bonnet. These clips fit into a...

These small brown clips are used on lots of Mitsubishi models. The clip is normally used to attach the rubber seals that run along the front and re...

These small white clips have a canoe shaped head that fits inside a rubber door seal. The clip then clicks into position on the door frame to secur...

Standard lock nuts or screw grommets used for mounting parts or trim to metal bodywork. These clips push into a square 8.5mm hole in the bodywork. ...

These distinctive expanding plastic rivets fit into a square hole measuring 9mm x 9mm. The centre pin of the clip has a cross head and the clip is ...