Volkswagen Touran Fixings Trim Clips and Fasteners -Mk1 (2003-2015)

These are used by manufacturers in the VAG group including Porsche. They attach onto interior trim covers normally on the A, B or C pillars of the ...

These clips are used with other plastic trim clips. This hard rubber grommet fits into a hole in the bodywork. A separate clip is inserted and the ...

These small white plastic grommets come with integrated rubber seals. They are very commonly used in the VW Group. They are used in a wide range of...

There are two very similar clips used by Audi, Seat, Skoda and VW on most of their models. This version is 16mm long and there is also a 22mm versi...

These small plastic grommets or lock nuts are used on a range of different vehicles within the VAG group. They are used in a number of different pl...

These are a chunky push fit plastic fastener with an integrated rubber seal. They are used on lots of different models in the VW group to attach do...

These spring clips are used on interior trim panels such as dashboards, centre consoles, pillar covers and roof consoles.

These locking star washers are suitable for attaching underbody noise and heat insulation. The corrosion resistant parts are used throughout the Vo...

There are two very similar clips used by Volkswagen on many of their cars and commercial vehicles. This clip is 22mm long and there is also a 16mm ...

These are very widely used across the VAG group. The grommet is used on a large number of parts including around bumpers, sills, side skirts, wheel...

This two part clip includes the black centre pin and the insert grommet that goes into the bodywork. The parts should be fitted assembled but will ...

This sprung clip is very simple. The clip squeezes together to be fitted and expands once it is in place. It is used on cars and vans across the VW...

This plastic fastener fits into an 8mm diameter hole and expands to securely lock in place when the centre pin is inserted. They are used by VW on ...

Used on many different VW cars, these 8mm push pin rivets are normally used for attaching inner wing shields, undertrays or bumper shields.

These distinctive clips attach roof lining panels, interior pillar covers and other trim panels onto many different Volkswagen models. They are a c...

These clips are used on the door card of a number of different vehicles. The black piece is removable and the white rectangle is normally bonded to...

This is a very common part used on a wide range of vehicles all related to the Volkswagen Group. The clip is used for a variety of purposes from at...

These are a very common metal clip on Volkswagen vehicles. Typical uses include door sill cover trims, tailgate linings and interior pillar covers.

These are very common on modern VW cars and vans. The nuts are almost always used to attach underbody shields and insulation.

These nuts have an unthreaded internal diameter of 3.9mm. The parts are normally fitted onto a coarsely threaded stud and the thread is cut into th...

These threaded nuts are typically used around the rear bumpers to secure brackets and mouldings.

These clips are used across the VW range for everything from mounting sensors to underbody shields and interior carpets and upholstery. All of our ...

This small white clip is used to attach the interior wing mirror cover trim. This trim is on the inside of the car door and hides the fixings that ...

A distinctive fastener used for position and securing the plastic sill covers on some door entrances and boot entrances. They are used by Volkswage...